How to collect dynamic images of the conveyor belt using the X-ray device?

I. Select a professional X-ray machine. Take the new mobile device KJ581-M from DMC as an example. The specification of the X-ray receptor is 2.2 meters.

II. Principles for choosing the installation location of the machine:
Relatively clean environment (little dust, little water), level floor, and easy access to electricity (at the head or tail location of the conveyor belt).
Location with sufficient installation space (the distance between the lower part of the belt and the floor is ≥ 1 meter).
The conveyor belt is flat and has little vibration.
The conveyor belt has no issues such as belt deviation.

III. Place the receptor on the frame of the conveyor belt or fix it on a customized support so that the X-ray receptor is 5 cm away from the lower part of the belt and the emitter window is aligned with the yellow line of the receptor. The operator should choose a safe area more than 40 meters away from the machine to place the laptop and make wired connections between all components.

IV. Before starting the conveyor belt, a preheating operation of the X-ray tube should be carried out. During this process, the radiation intensity corresponding to the optimal image can be found in the software.

V. Pre-configure the following three parameters in the software: the length of the conveyor belt to be scanned, the number of sensor cards, and the belt speed. Wait until the conveyor belt has been running for a while and until its speed is uniform. Then, start collecting images in the software. Once the scanning is completed, the system will automatically shut down, the X-ray emission will stop immediately, and the image data will be automatically saved to the hard drive of the laptop.